Tutorial Mikrotik VPN : EoIP

Ethernet over IP (EoIP) Tunneling is a MikroTik RouterOS protocol that creates an Ethernet tunnel between two routers on top of an IP connection. The EoIP interface appears as an Ethernet interface. When the bridging function of the router is enabled, all Ethernet level traffic (all Ethernet protocols) will be bridged just as if there where a physical Ethernet interface and cable between the two routers (with bridging enabled). This protocol makes multiple network schemes possible.
Network setups with EoIP interfaces:

Possibility to bridge LANs over the Internet
Possibility to bridge LANs over encrypted tunnels
Possibility to bridge LANs over 802.11b 'ad-hoc' wireless networks

An EoIP interface should be configured on two routers that have the possibility for an IP level connection. The EoIP tunnel may run over an IPIP tunnel, a PPTP 128bit encrypted tunnel, a PPPoE connection, or any connection that transports IP.
Specific Properties:

Each EoIP tunnel interface can connect with one remote router which has a corresponding interface configured with the same 'Tunnel ID'.
The EoIP interface appears as an Ethernet interface under the interface list.
This interface supports all features of and Ethernet interface. IP addresses and other tunnels may be run over the interface.
The EoIP protocol encapsulates Ethernet frames in GRE (IP protocol number 47) packets (just like PPTP) and sends them to the remote side of the EoIP tunnel.
Maximal count of EoIP tunnels is 65536.

This is how to set up EoIP to bridge two (or more) Mikrotik routers for central PPPoE authentication

Using 2 routers called R1 and R2 that have an IP connection between them and R2 has 2 ethernet ports, i.e. you can ping rB from R1 and R1 from R2 where the R1 facing eth port is called eth1 and its other port is called eth2.

1. create a new EoIP tunnel on R1.
2. create a new EoIP tunnel on R2, where the tunnel ID is the same as the one on R1 but the MAC addreses are different.
4. create a new bridge on R1 and R2
3. add a PPPoE server to the Bridge on R1.
4. on R2 and add eth2 and the EoIP tunnel to the bridge.
5. put an IP address onto eth2 (any address seems to work, but it maybe better to use a different subnet for routing purposes).

Now you should be able to establish a PPPoE connection from a PC plugged into the eth2 port on router R2, this PPPoE connection will terminate on router R1.

This is not the most efficient method of using the available bandwidth on a network, but is perhaps easier than having a PPPoE A/C on every Mikrotik router and using RADIUS as you can just have PPP secrets setup on one router.


taken from [You must be registered and logged in to see this link.]

wah ribet amat bahasanya,,, xixixixi nyimak gan,,, ane gak ngerti bahasa nya,,

injin nyimak dolo gan

kan bisa manfaatin translatenya google om

badewei nais tutor gan

setau saya eoip berfungsi untuk melakukan bridging antara 2 MikroTik yang terpisah dan membuat 2 unit MikroTik tersebut berkerja sebagai switch. semacam network sharing antar dua koneksi yang berbeda

thanks mas admin atas penejelasannya